C and CFR Variety Functionality Data

C Type Flex-Flex Couplings
The C Form coupling consists of two flex hubs, 1 sleeve and one particular accessory kit consisting of seals and snap rings.
CFR Sort Flex-Rigid Couplings
The CFR Variety coupling include a single flex hub, 1 rigid hub, a single sleeve, one accessory kit consisting of seals and snap rings.
Характеристики
Basic and cheap type of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in spot
Out there as vertical and horizontal couplings
Broad variety of particular variations which include full-flex, flex-rigid mill motor
Normal configurations can be found in the shelf
Ordering Information and facts
Application: Driver and Driven.
Variety and dimension of coupling, horizontal, vertical and so on.
Electrical power: Motor horspower or torque necessity.
Velocity: Motor RPM or Driven RPM.
Distance between shaft ends (BSE).
Shaft sizes.
C and CFR Sort Couplings
Ordering Facts
Puller Holes are conventional on sizes four through twelve.
Puller Holes are available for sizes 7/8 through 3.five at an extra charge.
The BSE (distance Between Shaft Ends) might vary involving G and G1.
Interference bores without any set screws are common unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, check with Engineering Segment.
Greater sizes can be found, please talk to Technical Assistance.