Power UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE one
Common Description
This electrical power unit is intended solely for that compact lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit is widely utilized while in the business of logistic units like minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed from the solenoid valve using the velocity managed by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
General Description
This power unit is created exclusively to the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve as well as the speed controlled from the adjustable needle valve. When the lift rises to a higher positoin, but the power provide is minimize, the decreasing motion is managed through the guide override perform.
Power UNITS FOR LIFT TABLE three
Common Description
This electrical power unit is built solely for that big lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve plus the speed managed by a strain compensated flow manage valve.
Electrical power UNITS FOR LIFT TABLE four
Basic Description
This energy unit is built exclusively for your significant lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and also the velocity managed through the adjustable needle valve. When the lift rises to a high positoin, but the energy provide is reduce, the lowering movement is controlled through the manual override function.
Unique Notes
1. This electrical power unit is of S3 duty cycle, which could only function intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all of the hydraulic elements concerned ahead of installation of the power unit.
3. Viscosity from the oil shoud be 15~46 cst,which ought to also be clean and totally free of impurities.N46 hydraulic oil is encouraged.
four. Oil transforming is needed immediately after the original 100 operation hours,afterwards as soon as every 3000 hrs.
five. The electrical power unit shown is designed to be mounted vertically.