Lifting System Electrical power Unit
1.These are compact-sized and lightweight energy deals that use nominal oil delivered from a tiny tank.
two.They come with a large-overall performance equipment pump mounted.
three.Since a manifold block can be mounted directly on the hydraulic pump as an choice, it is easy to configure the hydraulic circuit of the user’s decision by setting up a little stack valve.
4.Entire return line filter is standard products which allows longer system life.
5.Selection of options are accessible,like temperature gauge,magnet,degree swap,manifold block,and so on.
|Voltage Of Electric Motor||Electricity Of Electrical Motor||Pump Displacement(ml/r)||Optimum Working Stress(Mpa)||Oil Tank Condition||Oil Tank Ability
|Control Style||Mounting type|
|AC380V AC220V ACWe also can style and make non-standard products to satisfy customers’ particular specifications. 415V AC450V AC110V||DC12V
DC36V DC48V DC60V DC72V
|234 56781012||Handbook operation
• In the course of original method startup (and startups after prolonged time period of storage), pump could have trouble drawing fluid. By pre-installing an air bleed valve (ABT-03) or by loosing a fitting in the shipping pipe, air can be bled from the program.
• In the course of air bleed of pump and piping, pump must be operate at no load.
In the course of startup, if viscosity is greater than correct viscosity (fifty four mm 2 /s), program need to be warmed up with strain less than half of maximum functioning stress until viscosity falls under fifty four mm 2 /s.
. Hydraulic Fluids
• Optimum operating pressures, maximum speeds,and so forth. specs may possibly vary in accordance to the hydraulic fluid utilized.
• Mineral oils
-Make sure you use common industrial use anti-use fluids.
• Hearth resistant fluids
-Drinking water glycols may possibly be utilized with us common sort pumps. Nonetheless optimum functioning pressures, maximum speeds, and many others., specs will differ from people of mineral oil fluids. You should refer to technical specs of every single pump for details.
-Fluorine seals are utilized with pumps that work on phosphate ester fluids. An “F3-” suffix
is utilized to designate this kind of pumps. However technical specs for maximum operating pressures, greatest speeds, and so on., will differ from individuals of mineral oil fluids.
Hydraulic Fluid Viscosity and Temperature
• You should work pump with viscosity degree inside thirteen~54 mm two /s range. Optimum viscosity authorized is 860 mm2/s (220 mm 2 /s for V20, V30 Collection), but heat up and procedure should be done in accordance with the paragraph on “Heat Up”.
• Fluid temperature need to be maintained beneath 65°C.