Tailboard Lifting Hydraulic Electricity Unit
one.These are compact-sized and lightweight energy offers that use nominal oil shipped from a small tank.
2.They arrive with a higher-efficiency equipment pump put in.
three.Because a manifold block can be set up directly on the hydraulic pump as an alternative, it is easy to configure the hydraulic circuit of the user’s decision by setting up a little stack valve.
4.Entire return line filter is standard gear which enables more time program existence.
five.Variety of options are accessible,like temperature gauge,magnet,amount change,manifold block,etc.
|Voltage Of Electric Motor||Power Of Electrical Motor||Pump Displacement(ml/r)||Optimum Functioning Strain(Mpa)||Oil Tank Condition||Oil Tank Capacity
|Control Style||Mounting style|
|AC380V AC220V AC415V AC450V AC110V||DC12V
DC36V DC48V DC60V DC72V
|234 56781012||Guide operation
• Throughout initial system startup (and startups soon after lengthy interval of storage), pump could have issues drawing fluid. By pre-setting up an air bleed valve (ABT-03) or by loosing a fitting in the delivery pipe, air can be bled from the program.
• Throughout air bleed of pump and piping, pump ought to be run at no load.
For the duration of startup, if viscosity is larger than correct viscosity (54 mm two /s), technique must be warmed up with pressure much less than 50 percent of highest operating pressure right up until viscosity falls below fifty four mm 2 /s.
. Hydraulic Fluids
• Optimum functioning pressures, optimum speeds,and so on. requirements might vary according to the hydraulic fluid used.
• Mineral oils
-Remember to use common industrial use anti-put on fluids.
• Hearth resistant fluids
-Water glycols may be used with us standard type pumps. Nonetheless optimum working pressures, greatest speeds, and so on., technical specs will vary from people of mineral oil fluids. Please refer to requirements of every pump for specifics.
-Fluorine seals are utilized with pumps that function on phosphate ester fluids. An “F3-” suffix
is used to designate these kinds of pumps. Nonetheless technical specs for highest functioning pressures, highest speeds, and so forth., will differ from those of mineral oil fluids.
Hydraulic Fluid Viscosity and Temperature
• Remember to operate pump with viscosity amount inside thirteen~54 mm 2 /s variety. Maximum viscosity authorized is 860 mm2/s (220 mm 2 /s for V20, V30 Sequence), but heat up and operation should be completed in accordance with the paragraph on “Heat Up”.
• Fluid temperature must be managed bAdvanced thermo treatment products, this kind of as community heat treatment method oven, multi-use thermo treatment method oven, and so forth. elow 65°C.