One strand sprocket with a single group of teeth around the circumference for applications where a single chain may support the torque and load
Pitch of 3/4 inch for size 60 chains
Sprocket bore and hub with QD fittings for inserting and locking bushings into place
Type B sprocket with a hub projection using one part to accommodate numerous kinds of bushings to help prevent sprocket from slipping on the shaft
Sprocket teeth help prevent slipping and binding to avoid power loss in assemblies
This Tsubaki roller chain sprocket includes a 3/4-inch pitch, fits size 60 chains, and is single strand with one set of teeth around its circumference for use with single strand chains. It is a Type B sprocket with a hub projection encircling the bore using one side, and both hub and bore have Quick-Disconnect (QD) fittings for inserting and locking into place different QD bushings based on the diameter of the shaft. The teeth of the sprocket help prevent slipping and binding in order to avoid power loss in assemblies. It fulfills International Company for Standardization (ISO) 9001 for quality assurance. This solitary strand roller chain sprocket is definitely ideal for use in a wide range of applications including light to moderate loads and ongoing, high-cycle operations, including automobile transmission systems, construction and agricultural equipment, conveyors, and factory production and assembly lines, amongst others.
A roller chain sprocket is a thin wheel with deep, uniformly spaced teeth ringing its circumference. The length from the peak of 1 tooth to another is called the pitch, and is commonly measured in 1/8-” increments. The sprocket transfers power and motion by a roller chain that’s threaded over the teeth of the sprocket. The alignment of the chain with the sprocket’s pitch stops the chain from slipping so that no power is certainly lost. In the heart of the sprocket may be the bore (hole) for sliding the sprocket onto a shaft, and a bushing or bearing is certainly often suited to the sprocket’s hub to custom-fit the sprocket onto a shaft to hold it firmly set up. A hub is certainly a protruding, elevated lip encircling the bore of the sprocket. Sprockets with hubs on both sides are Type C, sprockets with hubs on one part are Type B, and sprockets with no hubs are Type A sprockets. For applications needing sprockets to end up being swapped onto shafts of different diameters, a sprocket with a bore huge enough to match all shafts can be used, with the gap between the bore and shaft closed with a bushing or bearing. Roller chain sprockets are used in a broad selection of applications where in fact the drive power of an engine must be transferred into movement, such as in automobiles, conveyors, escalators, agricultural, forestry and mining products, aeronautics, robotics and space exploration, amongst others.
U.S. Tsubaki Power Tranny manufactures a number of chains, sprockets, and additional power transmission parts that meet International Firm for Standardization (ISO) specifications for quality assurance. The business, founded in 1917, is definitely headquartered in Wheeling, IL.